Services

Services

Because of his experiences on the special area „Static Control“ (ESD) for years, Mr. Berndt wrote the practically oriented book „Elektrostatik – Ursachen, Wirkungen, Schutzmaßnahmen, Messungen, Prüfungen, Normung“. The 3rd edition was published by the VDE in autumn 2009. It is guidance for all companies, where electrostatic charges must be avoided. Mr. Berndt’s second book „ESD – Schutz – Normen, Konzepte und Messtechnik“ was published by Expert.

This one is needed by specialists and managers in the process engineering, production process and quality management, including an Static Control Program.

In the in-house training centre, the B.E.STAT European ESD competence centre educates and trains ESD coordinators. Themes, like the actual European and international standards as well as measurement trainings belong to a standard training.

Analysis, ESD Control Program and Certification

We offer you:

  1. Analysis of electronics production and its ESD equipments
  2. Development of a concept for a production area
  3. Development of an ESD control program
  4. Monitoring of the introduction process for an ESD control program
  5. Certification of an introduced ESD control program
  6. Periodic monitoring of an introduced ESD control program

Inspections, audits and assessments

We offer the following services in the field inspections, audits and reports:

Inspections, opinions and reports

Perform of measurements according to the analysis of a production as well as the creation of acceptance reports

Auditing of manufacturing, jobs, facilities and equipment

The audits are performed in accordance with standards IEC 61340-5-1 and IEC 61340-5-1 Supplement 1 (IEC 61340-5-1 and IEC 61340-5-2) and the American standards and regulations ANSI / ESD S20.20 -2007 and ANSI/EIA-625A, creating a verification opinion